Here is a photo of the forward camera installed at the top of the front middle window. I am standing outside taking a photo of the window in the raised position. This camera is installed over the front dinette table. The wires are ran along the window frame toward the front left of the Airstream.
This photo is taken from inside the Airstream of the forward camera. This camera is positioned above the front dinette table and is on the outside of the screen attached to the window. The wires are ran along the window frame toward the front left of the Airstream.
This photo is taken of the left front window and shows the metal frame of the center window. The plastic gray shroud was removed at the top of this photo so the BlackVue wire harness from the front camera could be ran underneath towards the left side curtain and left dinette cushion.
This photo is taken inside the Airstream behind where the left side dinette back cushion is places. The left side lower cushion is still in place in this photo. In the upper right portion of this photo you can see where the wire harness comes out from the window frame and then is ran down below the left dinette seat.
This is a photo of the same left front dinette seat removed. In the left side of the photo you can see the BlackVue camera harness go down below the bottom the left dinette seat.
In the upper left portion below the dinette seat, you can see the black wire harness ran back toward the front portion of the Airstream. The Power Magic Pro is mounted to the top of the board in the shadow area.
This is a close-up photo of the Power Magic Pro module mounted to the left of my Victron Energy Bluetooth dongle.
This photo taken from inside the Airstream over the bed. This rearward facing camera is mounted to the rear facing window. The wire which leads to the front camera is ran through a small hole in the top of the screen and to the right toward the bathroom shower.
The wire from the rear camera is ran down the corner of the wall which backs up to the shower. The wire then comes across and under the bed frame.
This is a pre-existing hole under the bottom of the Airstream near the back right corner. The small black wire was fed down through this hole from under the bed in between the thin copper pipe and thicker wire harness. The black wire is then ran along the frame, up to the front and up to the front camera.